You are not logged in.
#1 2010-06-09 13:10:49
- Yuca
- Member
- Posts: 8544
Removing tags from G9s
Has anyone done this? Much as I detest the tags, I'm concerned that if I cut them off, a white line will remain from where the tag has been sewn in, and this line could look even worse than the tag (horrific thought).
Obviously if I was a real face I'd have a complete G9 collection from before tags were introduced, but I'm afraid I'm not that cool.
some sort of banal legitimacy
#2 2010-06-10 00:56:07
- Taylor McIntyre
- Son of Ivy...
- Posts: 342
Re: Removing tags from G9s
Pull the seam as far open as you can. Slide a ruler under the tag. Slice along the top of the tag with a craft knife / Stanley knife / scalpel. Mind your fingers!
The more open you pull the seam & the higher you slice, the better the result.
Last edited by Russell_Street (2010-06-10 00:56:24)
#3 2010-06-10 22:34:24
- Horace
- Member
- Posts: 6432
Re: Removing tags from G9s
Does the G9 now have a tag on the outside of the jacket?
""This is probably the last Deb season...because of the stock market, the economy, Everything..." - W. Stillman.
#5 2010-06-13 07:50:41
- Yuca
- Member
- Posts: 8544
Re: Removing tags from G9s
Thanks, a good explanation, I'll attempt it once I've found my/bought a new scalpel.
some sort of banal legitimacy
#6 2010-06-13 14:55:23
- Bishop of Briggs
- Member
- Posts: 3948
Re: Removing tags from G9s
The Fred Perry laurel range has a G9 clone that is made in England. It is probably made by Baracuta, or the same factory, but does not have a logo on the front. See http://www.stuartslondon.com/product/FRED%20PERRY%20LAUREL/Fred%20Perry%20Laurel/Harrington%20Jacket%20%20Navy%20Made%20in%20England/#.
Contrary to lies of FNB and Woofboxer, I (and most of the other "Buff Bastards") have been banned from posting on this forum. There are only a few posters left so don't waste your time on here. This forum is dead and nobody cares.